Support daltonyoungblood@empressaudio.com

Bass package

Kenwood put together this bass party pack so you can enjoy the bold, punchy bass in your music that was missing. The package includes two tough 10″ component subs along with a 170-watt amplifier — all you need is a subwoofer box and an amp wiring kit for a complete bass system that’ll help every ride rock.

The subwoofers

Kenwood’s KFC-W110S 10″ subwoofer features an injection-molded polypropylene cone with a thick urethane surround, a combination that promotes deep excursion and accurate bass response. Each sub can handle up to 175 watts RMS. The two component subwoofers can mount singly or together, in sealed or ported boxes.

The amplifier

Kenwood’s KAC-5207 2-channel amplifier will power the subs with up to 170 watts RMS in mono mode. The amp’s speaker-level inputs with signal sensing turn-on allow you to install it in just about any kind of system, even one using a factory radio.

Note: The power of the amp in this bass package is significantly less than the manufacturer’s recommended power handling for the included subs. It’s OK to under-power your subs, as long as you set the amp gain properly and avoid distortion. This diagram shows you how to wire the subs to the amp in this package.

READ LESS

Product highlights:

  • package includes two KFC-W110S 10″ subwoofers and a Kenwood KAC-5207 2-channel amplifier
Two KFC-W110S 10″ 8-ohm subwoofers
  • injection-molded polypropylene woofer cone with high-roll urethane surround
  • black stamped-steel basket
  • power range (per sub): 45-175 watts RMS (700 watts peak power)
  • frequency response: 35-1,000 Hz
  • sensitivity: 90 dB
  • top-mount depth: 4-7/8″
  • sealed box volume (per sub): 1 cubic foot
  • ported box volume (per sub): 1.25 cubic feet
  • grilles not included
  • warranty: 1 year
KAC-5207 2-channel amplifier
  • 70 watts RMS x 2 at 4 ohms (85 watts x 2 at 2 ohms)
  • 170 watts RMS x 1 bridged at 4 ohms
  • CEA-2006 compliant
  • Class AB design
  • switchable low-pass filter (80 Hz, 18 dB per octave)
  • preamp and speaker-level inputs
  • fuse rating: 25A x 1
  • wiring and hardware not included with amplifier
    • 10-gauge power and ground leads recommended
  • dimensions: 9-1/16″W x 2-3/16″H x 6-9/16″D
  • warranty: 1 year
  • MFR # P-W1021

What’s in the box:

    • This Kenwood Amp/Sub Package contains three individually-packaged items inside one box: one KAC-5207 Amplifier and two KFC-W110S Subwoofers

  • The KAC-5207 Amplifier box contains:
    • 2-Channel amplifier
    • 25A ATO fuse (installed)
    • 9″ Speaker-level input harness
    • Four 5/8″ Self-tapping screws
    • Instruction manual (English/ French/ Spanish)
    • Warranty information
    • Each KFC-W110S Subwoofer box includes:

  • One 10″ Single Voice Coil 8-ohm subwoofer
  • Eight 1″ Self-tapping screws
  • Adhesive backed foam gasket
  • Instruction Manual (English/ Spanish/ German/ French)
  • Warranty information

Reviews

There are no reviews yet.

Be the first to review “Kenwood P-W1021 10″ bass Party Pack”

Your email address will not be published. Required fields are marked